EM-7415

How to install the Engine Torque Strut Mount

Lower or Front Lower or Rear LowerFits 11 cars

Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.

All 11 cars it fits
YearsMakeModelEngineChoose
2016–2025MiniCooperL3 1.5L
2017–2025MiniCooperL4 2.0L
2021–2024MiniCooper—
2020–2021BMW228i xDrive Gran CoupeL4 2.0L
2020–2021BMWM235i xDrive Gran CoupeL4 2.0L
2016–2021BMWX1L4 2.0L
2018–2021BMWX2L4 2.0L
2017–2021MiniCooper CountrymanL3 1.5L

Where it goes

FRONT OF CARENGINEDRIVER SIDEPASSENGER SIDE111
  • 1Engine Torque Strut Mount: Lower or Front Lower or Rear Lower

Install steps

  1. 1

    Get the car ready

    Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.

  2. 2

    Support the engine

    Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.

  3. 3

    Engine Torque Strut Mount

    Lower or Front Lower or Rear Lower. Remove the old mount and bolt the new one in hand-tight.

  4. 4

    Tighten, lower, test

    Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.

Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.