Automatic Transmission Mount

EM-4206

How to install the Automatic Transmission Mount

Rear or Front or Front Left or Rear LeftFits 10 cars

Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.

All 10 cars it fits
YearsMakeModelEngineChoose
2008–2012ChevroletMalibuV6 3.6L
2008–2010ChevroletMalibuL4 2.4L
2004–2010ChevroletMalibuV6 3.5L
2008–2010PontiacG6L4 2.4L
2005–2010PontiacG6V6 3.5L
2007–2009PontiacG6V6 3.6L
2007–2009SaturnAuraL4 2.4L
2007–2009SaturnAuraV6 3.6L

Where it goes

FRONT OF CARENGINEDRIVER SIDEPASSENGER SIDE1111
  • 1Automatic Transmission Mount: Rear or Front or Front Left or Rear Left

Install steps

  1. 1

    Get the car ready

    Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.

  2. 2

    Support the engine

    Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.

  3. 3

    Automatic Transmission Mount

    Rear or Front or Front Left or Rear Left. Remove the old mount and bolt the new one in hand-tight.

  4. 4

    Tighten, lower, test

    Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.

Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.