Front Engine Torque Strut Mount

EM-2799

How to install the Front Engine Torque Strut Mount

FrontFits 4 cars

Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.

All 4 cars it fits
YearsMakeModelEngineChoose
1991–1997ChevroletLuminaV6 3.4L
1995–1997ChevroletMonte CarloV6 3.4L
1991–1996OldsmobileCutlass SupremeV6 3.4L
1991–1996PontiacGrand PrixV6 3.4L

Where it goes

FRONT OF CARENGINEDRIVER SIDEPASSENGER SIDE1
  • 1Front Engine Torque Strut Mount: Front

Install steps

  1. 1

    Get the car ready

    Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.

  2. 2

    Support the engine

    Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.

  3. 3

    Front Engine Torque Strut Mount

    Front. Remove the old mount and bolt the new one in hand-tight.

  4. 4

    Tighten, lower, test

    Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.

Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.