EM-2761
How to install the Front Engine Torque Strut Mount
FrontFits 1984–1988 Pontiac Fiero
Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.
The car it fits
| Years | Make | Model | Engine | Choose |
|---|---|---|---|---|
| 1984–1988 | Pontiac | Fiero | L4 2.5L |
Where it goes
- 1Front Engine Torque Strut Mount: Front
Install steps
- 1
Get the car ready
Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.
- 2
Support the engine
Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.
- 3
Front Engine Torque Strut Mount
Front. Remove the old mount and bolt the new one in hand-tight.
- 4
Tighten, lower, test
Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.
Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.