Drive Shaft Center Support

DS-6552

How to install the Drive Shaft Center Support

Fits 8 cars

Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.

All 8 cars it fits
YearsMakeModelEngineChoose
1998–2003Mercedes-BenzCLK320V6 3.2L
1999–2003Mercedes-BenzCLK430V8 4.3L
2001–2002Mercedes-BenzCLK55 AMGV8 5.5L
1998–2000Mercedes-BenzC280V6 2.8L
1998–2000Mercedes-BenzC43 AMGV8 4.3L
1994–1998Mercedes-BenzC280L6 2.8L
1995–1997Mercedes-BenzC36 AMGL6 3.6L
1997Mercedes-BenzSLK230L4 2.3L

Install steps

  1. 1

    Get the car ready

    Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.

  2. 2

    Support the engine

    Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.

  3. 3

    Drive Shaft Center Support

    Remove the old mount and bolt the new one in hand-tight.

  4. 4

    Tighten, lower, test

    Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.

Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.