Drive Shaft Center Support

DS-6533

How to install the Drive Shaft Center Support

Fits 8 cars

Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.

All 8 cars it fits
YearsMakeModelEngineChoose
2010–2015FordF-350 Super DutyV8 6.2L
2011–2015FordF-350 Super DutyV8 6.7L
2011–2013FordF-350V8 6.2L
2008–2010FordF-350 Super DutyV10 6.8L
2008–2010FordF-350 Super DutyV8 5.4L
2008–2010FordF-350 Super DutyV8 6.4L
2007–2009FordF-250V8 4.6L
2008–2009FordF-350V8 5.4L

Install steps

  1. 1

    Get the car ready

    Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.

  2. 2

    Support the engine

    Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.

  3. 3

    Drive Shaft Center Support

    Remove the old mount and bolt the new one in hand-tight.

  4. 4

    Tighten, lower, test

    Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.

Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.