Drive Shaft Center Support

DS-6509

How to install the Drive Shaft Center Support

Fits 9 cars

Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.

All 9 cars it fits
YearsMakeModelEngineChoose
2003–2009DodgeRam 2500L6 5.9L
2007–2009DodgeRam 2500L6 6.7L
2003–2009DodgeRam 2500V8 4.7L
2003–2009DodgeRam 2500V8 5.7L
2007–2009DodgeRam 3500L6 6.7L
2003–2009DodgeRam 3500V8 5.7L
2003–2008DodgeRam 3500L6 5.9L
2003DodgeRam 2500V10 8.0L

Install steps

  1. 1

    Get the car ready

    Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.

  2. 2

    Support the engine

    Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.

  3. 3

    Drive Shaft Center Support

    Remove the old mount and bolt the new one in hand-tight.

  4. 4

    Tighten, lower, test

    Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.

Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.