Drive Shaft Center Support

DS-6503

How to install the Drive Shaft Center Support

Fits 8 cars

Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.

All 8 cars it fits
YearsMakeModelEngineChoose
2005–2011CadillacSTSV6 3.6L
2005–2010CadillacSTSV8 4.6L
2006–2009CadillacSTSV8 4.4L
2005–2007CadillacCTSV6 2.8L
2004–2007CadillacCTSV6 3.6L
2006–2007CadillacCTSV8 6.0L
2004–2005CadillacCTSV8 5.7L
2003–2004CadillacCTSV6 3.2L

Install steps

  1. 1

    Get the car ready

    Park on level ground, set the parking brake and disconnect the battery. Lift the car and support it on jack stands.

  2. 2

    Support the engine

    Put a jack with a block of wood under the oil pan, or use an engine support bar. Do this before you take out any mount.

  3. 3

    Drive Shaft Center Support

    Remove the old mount and bolt the new one in hand-tight.

  4. 4

    Tighten, lower, test

    Lower the engine back down and tighten every bolt to your car's spec. Reconnect the battery, start the engine and check for movement or noise.

Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.