Rear Suspension Shock Absorber

AS-7404

How to install the Rear Suspension Shock Absorber

RearFits 13 cars

Pick your car in the car picker at the top of the page to check it fits and see the notes for your car.

All 13 cars it fits
YearsMakeModelEngineChoose
2006–2009ChevroletUplanderV6 3.9L
2006–2009PontiacMontanaV6 3.9L
2006–2007BuickTerrazaV6 3.9L
2006–2007SaturnRelayV6 3.9L
2005–2006BuickTerrazaV6 3.5L
2005–2006ChevroletUplanderV6 3.5L
2005–2006PontiacMontanaV6 3.5L
2005–2006SaturnRelayV6 3.5L

Where it goes

FRONT OF CARDRIVER SIDEPASSENGER SIDE11
  • 1Rear Suspension Shock Absorber: Rear

Install steps

  1. 1

    Turn the air suspension off

    Switch the air suspension off and let the system vent before you open any air line.

  2. 2

    Get the car ready

    Lift the car, support it on jack stands and take the wheel off. Support the axle or control arm.

  3. 3

    Rear Suspension Shock Absorber

    Rear. Disconnect the air line, remove the old part, fit the new one and reconnect the air line until it clicks.

  4. 4

    Turn it back on and test

    Switch the air suspension back on, start the engine and let the system fill. Check for hissing and that the car sits level.

Torque values: Use the torque values in your car's service manual. We only show a number here once it is checked for your car.